Product Details | STRAIGHT SHAFT

3040-00-092-5513 A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see GEARSHAFT (as modified). For items designed to support rotating members see AXLE(1), STRAIGHT. For items not having the above conditions see PIN, STRAIGHT, HEADLESS. For items having machined ends which constitute steps see SHAFT(1), SHOULDERED; AXLE(1), SHOULDERED; and BOLT, FLUID PASSAGE.20310050000101500003040000000

Part Alternates: 000925513

Aircraft and Airframe Structural Components | Airframe Structural Components

Supply Group (FSG) NSN Assign. NIIN
15 00-092-5513

Drawings & Photos | NSN 1560-00-092-5513


Request a Quote

What Our Customers Say

Compare

NSNs for Compare ( up to 4 ): Add 3040-00-092-5513

Technical Data | NSN 3040-00-092-5513

Characteristic Specifications
MATERIAL STEEL COMP 4130
MATERIAL DOCUMENT AND CLASSIFICATION MIL-T-6736,TY 1,COND N MIL SPEC SINGLE MATERIAL RESPONSE
FIRST END STYLE 11 UNTHREADED CROSS DRILLED
FIRST END DIAMETER 0.4875 INCHES MINIMUM AND 0.4880 INCHES MAXIMUM
FIRST END HOLE DIAMETER 0.1610 INCHES NOMINAL
FIRST END DISTANCE FROM HOLE CENTER TO END 0.469 INCHES NOMINAL
FIRST END HOLE DEPTH ANY ACCEPTABLE
END SIMILARITY NOT IDENTICAL
SECOND END STYLE 11 UNTHREADED CROSS DRILLED
SECOND END DIAMETER 0.4875 INCHES MINIMUM AND 0.4880 INCHES MAXIMUM
SECOND END HOLE DIAMETER 0.1880 INCHES NOMINAL
SECOND END DISTANCE FROM HOLE CENTER TO END 0.656 INCHES NOMINAL
SECOND END HOLE DEPTH ANY ACCEPTABLE
OVERALL LENGTH 2.125 INCHES NOMINAL
MANUFACTURERS CODE 97499
DESIGN CONTROL REFERENCE 47-631-106-1

Restrictions/Controls & Freight Information | NSN 3040-00-092-5513

Category Code Description
Hazardous Material Indicator CodePThere is no information in the HMIS; however, the NSN is in an FSC in Table II of Federal Standard 313 and an MSDS may be required by the user. The requirement for an MSDS is dependent on a hazard determination of the supplier or the intended end use of the product
Category Code Description
No Freight Information